Editor’s Note: While this piece dives pretty deep into the weeds of the science behind energy storage technology, it highlights the constant advancements we can expect in this field as it applies to large-scale energy storage and possibly smaller electronic devices.
Source: Lawrence Livermore National Laboratory
Lawrence Livermore National Laboratory (LLNL) scientists have created vertically aligned single-walled carbon nanotubes on metal foils that could be a boon for energy storage and the electronics industry.
Vertically aligned carbon nanotubes (VACNTs) have exceptional mechanical, electrical and transport properties in addition to an aligned architecture, which is key for applications such as membrane separation, thermal management, fiber spinning, electronic interconnects and energy storage.
To date, widespread integration of VACNTs into next-generation technologies is thwarted by a lack of compatible, economic, mass-production capabilities. High-quality VACNTs are typically made on substrates such as silicon (Si) or quartz wafers that are rigid, expensive and electrically insulating.
Also Read: Four Tips to Prepare for Energy Storage System Incidents
After exploring metal foil options in scientific literature, the LLNL team turned to Inconel metal substrates allowing them to integrate VACNTs into flexible devices, eliminate a transfer step from Si to other substrates and minimize electrical or thermal transport resistances at the interface between CNTs and the substrate, which is critical for electronic and energy storage applications. Inconel is a family of nickel-chromium-based superalloys that are oxidation-corrosion-resistant materials well-suited for service in extreme environments subjected to pressure and heat.
“Transitioning growth of high-quality CNTs from traditional Si substrates to metal foils opens the door to more economical, large-scale, semicontinuous and roll-to-roll manufacturing of multifunctional CNT composites, nanoporous membranes and electrochemical devices,” said LLNL scientist Francesco Fornasiero, co-author of a paper appearing in the journal Applied Materials & Interfaces.
Synthesis of high-quality single-walled CNTs (SWCNTs) on metal foils would be especially valuable for energy-storage devices, such as lithium-ion batteries (LIBs). While graphitic materials are common LIB anodes, their capacity falls short of rapidly evolving energy-storage needs.
Also Read: Illegal Lithium Battery Transport Burns Just Before Going to Sea
“The high surface area and exceptional electronic conductivity of CNTs make them prime candidates for high-capacity, high-rate electrochemical applications,” said LLNL scientist Kathleen Moyer-Vanderburgh, lead author of the paper. “In particular, VA-SWCNTs grown on metal foils could provide a binder-free platform with strong adhesion between the SWCNT and current collector, enhanced conductivity and aligned channels for rapid Li-ion diffusion.”
The LLNL team grew forests of vertically aligned SWCNT on Inconel metal for use as a LIB anode. Team members found nearly invariant structural properties of the CNT forests over a wide range of synthesis conditions and for multiple metal substrates. Fabricated VA-SWCNT LIB anode displayed stable cycling for hundreds of cycles and large capacity even at high cycling rates.
“Our results suggest that these SWCNTs on Inconel metal are promising materials for high-performance electrochemical devices,” said LLNL scientist Jianchao Ye.Other LLNL authors include Meghann Ma, Sei Jin Park, Melinda Jue, Steven Buchsbaum, Kuang Jen Wu and Marissa Wood. The work was funded by the Chemical and Biological Technologies Department of the Defense Threat Reduction Agency and the LLNL LDRD Program.
Original post – Copyright © 2023 HazmatNation.com. Externally linked references may hold their own independent copyright not assumed by HazmatNation
